MINI-319 Technical Datasheet

01Overview

A miniature 319.5 MHz magnetic contact

The Versa Wireless MINI-319 is a miniature wireless door and window transmitter for 319.5 MHz security systems. That's the Qolsys IQ panels, once you've fitted the 319.5 MHz SRF card, and the GE and Interlogix-class panels that have always listened on that band. It enrolls on a standard perimeter zone, so your panel treats it like any other 319.5 MHz contact it already knows.

What sets it apart is the install experience. Our patented Bluefield indicator lights a blue LED when the magnet and the transmitter are lined up and in range. So you see the answer at the opening instead of guessing. The high-power neodymium magnet gives you up to 1 in. of gap on wood and 1/4 in. on metal. And the whole transmitter is only 0.25 in. deep.

Battery service is the other thing installers notice. The lid slides off by hand, so you change the CR2032 or swap the color cover without pulling the electronics out of the plastics. And with an average battery life of 5+ years, you won't be doing that often.

02Features

Key features of the MINI-319

• Patented Bluefield magnet alignment, so the blue LED shows you the magnet and transmitter are clearly aligned and working before you press the tape down.
• 5+ year battery life on one Panasonic CR2032, which means fewer truck rolls for a dead cell.
• Easy-open slide lid, so battery replacements and color changes are quick, and you never pull the board out of the case.
• Pre-installed adhesive tape on the transmitter and the magnet, so you mount both on a clean frame with no drilling.
• Battery pull-tab to activate, which keeps the cell fresh until the sensor goes on the wall.
• A high-power neodymium magnet, which gives you up to 1 in. of gap on wood and 1/4 in. on metal.
• Three LEDs that tell you what's happening, blue for magnet in range, green for transmit and red for low battery.
• A 2.2 x 1 x 0.25 in. transmitter, so it sits nearly flush on tight casing and in narrow window channels.

03Specifications

MINI-319 technical specifications

The same figures you'll find on the product page and in the installation manual.

Mount the transmitter on the frame and the magnet on the door or sash, not on the glass. Keep both clear of metal, foil wallpaper and moisture. Fit only the specified Panasonic CR2032. Use of another battery may present a risk of fire or explosion.

04Panels

Panels the MINI-319 works with

The MINI-319 works with Qolsys IQ panels and GE/Interlogix-class panels that receive 319.5 MHz. Qolsys IQ panels hear 319.5 MHz once the Qolsys 319.5 MHz SRF card is fitted. That covers the IQ Panel 2+, IQ Panel 4, IQ4 Hub and IQ Panel 5. Those panels run PowerG plus one legacy band at a time, so the card in the slot decides which frequency the panel hears. Our guide to 319.5 MHz sensors on the Qolsys IQ Panel 4 and 5 lists the card part numbers and the software level.

From the box to the panel in three moves

1. Fit the battery

   Slide the cover open, fit the CR2032 plus side up and slide it back on. The blue and green LEDs run for 15 minutes.

2. Learn it in

   Put the panel in autolearn, then open and close the magnet once. The panel reads the built-in serial number and you name the zone.

3. Mount it

   Run the Go/No Go test from the spot, then press the transmitter onto the frame and the magnet onto the door with the blue LED lit.

Documentation: the MINI-319 installation manual has the step-by-step, and the Versa panel compatibility guide matches every Versa frequency to the panels that read it.

05Dimensions

Mechanical

The transmitter and the magnet, the way you'll measure them on the bench.

You mount both pieces with the supplied double-faced tape. Keep them off the glass and off metal surfaces, because metal pulls the magnet's field and shortens the gap you can rely on.

06Ordering

Part numbers and what goes with it

• MINI-319, the 319.5 MHz door and window contact, white, with the magnet and the double-faced tape in the box. The MINI-319 product page has the photos and the full write-up.
• MINI brown and black cover packs, which fit the MINI-319, MINI-345 and MINI-433 because the housing is common across the family. You'll find them in accessories.
• SHOCK-319 and PIR-319, the shock sensor and the pet-immune motion detector that sit on the same 319.5 MHz panel, so you cover the perimeter and the interior on one frequency.
• MINI-345 and MINI-433, the same sensor for 345 MHz and 433 MHz panels, listed side by side in door and window sensors.

Dealers order through the distributors on our Where to buy page, and if you've got a question on a specific panel, contact Versa Wireless.